Setting Destination and Endpoint types in Boomi Solace Connector

Options
Poornima
Poornima Member Posts: 25
edited February 2021 in General Discussions #1

Hi,
In my Boomi process - I have Solace queue listener and once data is sent to destination (end system) the end system responses are logged to another response queue in Solace. As the response section is common for another modules as well. I like to set the Destination queue name in Set properties in Boomi and tried to call subprocess (which sends the response message to Solace response queue). In this case Solace is not identifiying the destination name when I set properties as below,


Could anyone please guide on why destination we need to specify only in Connector operation not as from properties side.

Tagged:

Comments

  • Poornima
    Poornima Member Posts: 25
    Options

    @TomF @cmorneau . Could you please suggest.

  • Poornima
    Poornima Member Posts: 25
    Options

    @TomF @cmorneau - this issue is sorted by sending Endpoint Type and Destination in Set properties.

  • marc
    marc Member, Administrator, Moderator, Employee Posts: 935 admin
    Options

    @Poornima said:
    @TomF @cmorneau - this issue is sorted by sending Endpoint Type and Destination in Set properties.

    Hi @Poornima,
    I just wanted to verify that you are saying that you resolved the issue by setting the properties? Or is there still an issue that you need help with?

  • amackenzie
    amackenzie Member, Employee Posts: 260 Solace Employee
    Options

    Could you show a screen shot of your process and sub-process?